Workout of the day 02/24/2012

Yesterday's workout focused on high intensity interval training, so for today we will take it down a notch and put some focus on our biceps and back. Here is what today's workout looks likes. Let's just keep it simple, but that doesn't mean that we can't work hard.

Exercise list:

• Cable seated rows
• Barbell Curl
• Wide-grip lat pull down
• Incline dumbbell curl
• Barbell deadlift
• Alternate hammer curl
• Cable lateral raise 

Do 3-5 sets of each exercise

I will not give you your reps #, but you should perform enough reps for each set that your muscles near fatigue or fatigue. Numbers can be so vague.

Rest for 30 - 60 sec in between sets 

Weight amount should be 60% - 85% of your one rep max. Higher your percentage = fewer reps (strength & hypertrophy training). Lower percentage = higher reps (endurance training). Use the following formula to determine your one rep max. Knowing your 1RM can be very helpful in developing your weight training regimen. 

1RM (Rep Max) formula: Use this math formula to determine what your one rep max is for each of the above exercises: This will help determine what amount you should lift. When lifting to determine your 1 RM follow these steps.

• ·        Lift what think you can lift in ten reps, but keep going until you are tired or can’t lift anymore
• ·         Rest for 3-4 minutes
• ·         Increase the weight and aim for ten reps, but keep going until you are tired or can’t lift anymore
• ·         Rest for 3-4 minutes
• ·         Increase the weight and aim for ten reps, but keep going until you are tired or can’t lift anymore
• ·         Repeat the above steps until only ten or fewer reps can be achieved

·       

  Then use the formula below to determine your 1 RM

Weight lifted = amount of weight you lifted for that set (wt)

# of reps =  amount of reps you lifted for that set (reps)

1RM= (wt x reps x 0.033) + wt

Example:

• ·         1RM = (135 x 8x 0.033) + 135
• ·         1RM = 35.64 + 135
• ·         1RM = 170.64 or 171

Once you have determined your 1 RM you need to determine your weight percentage for your exercise.

Assume that 65% is the percentage of your 1RM that you are to lift.

1RM x RM% = Desired weight

Example:

·         

171 x 0.65 = 110.9 or 111

Pick the closest weight. Obviously 111 doesn’t exist, so lift 110.